Panasonic DMR-XW300 - Manual (Page 16)

16
RQT9135
STEP
1
Connection
≥Before connection, turn off all equipment and read the appropriate operating instructions.
≥Refer to “Additional connections” ( ➡ 91) for connection using other terminals and connection with other equipment.
When the unit is not to be used for a long time
To save power, unplug it from the household mains socket. This unit consumes a small amount of power, even when it is turned off
[approx. 3 W (Power Save mode)]
When “Power Save” is set to “On”, the “Quick Start” function does not work.
Connecting a television
Connecting to a television with 21-pin Scart terminal
You can also connect with the AV1 terminal on this unit using the 21-pin Scart cable.
If your television is equipped with RGB input capability, by connecting with a fully wired 21-pin Scart cable you can see video using RGB
output on this unit.
[Required]setting]
“AV1 Output” in the Setup menu (
➡ 85)
RF RF
IN
IN
RF RF
OUT
OUT
A V2 ( EXT )
A V 1
( TV )
OPTICAL COAXIAL
COMPONENT COMPONENT
VIDEO OUT VIDEO OUT
OUT O U T
A V 4 I
N
A V 4 I N
S VIDEO VIDEO R- A UDIO- L
P R P B Y
A C IN
10BASE-T/
100BASE-TX
DIGITAL DIGITAL AUDIO OUT AUDIO OUT
(PCM/BITSTREAM) (PCM/BITSTREAM)
VHF/UHF
RF IN
2
4 3
AUDIO IN
R L
VIDEO IN
1 2
This unit’s rear panel
Red White Yellow
Red White Yellow
Audio/Video cable
(included)
Other connections
(
➡ 17, 91)
RF coaxial
cable
(included)
To the aerial
Aerial cable
Television’s rear panel
To household mains socket
(AC 220 to 240 V, 50 Hz)
AC mains lead
(included)
Connect only after all other
connections are complete.
Cooling fan
DMRXW300GN-RQT9135-L_eng.book 16 ページ ２００８年４月３０日 水曜日 午後６時１１分