Panasonic DMR-XW300 - Manual (Page 17)

17
RQT9135
You can enjoy high-quality picture by changing the connection between this unit and your TV on page 16 as follows.
.
When connected to an HDMI compatible unit, an uncompressed digital audio and video signal is transmitted. You can enjoy high quality, digital
video and audio with just one cord. When connecting to an HDMI-compatible HDTV (High Definition Television), the output can be switched to
1080p, 1080i or 720p HD video.
≥This unit incorporates HDMI
TM (V.1.3 with Deep Colour) technology.
≥Video sources converted to 1920k1080 resolution, while of high quality, will exhibit somewhat lower subjective image resolution than true,
native 1080p full-HD sources. See dealer for details.
≥Please use High Speed HDMI Cables that have the HDMI logo (as shown on the cover).
≥When outputting 1080p signal, please use the HDMI cables 5.0 meters or less.
[Note]
≥If you are connecting to a TV that is only compatible with 2 channel audio output, audio with 3 channels or more will be down mixed ( ➡ 110) and
output as 2 channels, even if connecting with an HDMI cable. (Some discs cannot be down mixed.)
≥You cannot connect this unit to DVI devices that are incompatible with HDCP.
For units compatible with HDCP (High-Bandwidth Digital Content Protection) copyright protection that are equipped with a digital DVI input
terminal (PC monitors, etc.):
Depending on the unit, images may not display properly or at all when connecting with a DVI/HDMI switching cable. (Audio cannot be output.)
Connecting to a TV with an HDMI (High Definition Multimedia Interface) cable
Regarding VIERA Link “HDAVI Control TM ” function
When connecting with a Panasonic TV (VIERA) or a receiver equipped with the “HDAVI Control” function, linked operations would be
possible. [
➡ 72, Linked operations with the TV (VIERA Link “HDAVI Control TM ”)]
≥Non-HDMI-compliant cables cannot be utilised.
≥It is recommended that you use Panasonic’s HDMI cable.
Recommended part number:
RP-CDHG10 (1.0 m), RP-CDHG15 (1.5 m), RP-CDHG20 (2.0 m), RP-CDHG30 (3.0 m), RP-CDHG50 (5.0 m), etc.
RF RF
IN IN
RF RF
OUT
OUT
AV2 (EXT)
AV1 (TV)
OPTICAL COAXIAL
COMPONENT COMPONENT
VIDEO OUT VIDEO OUT
OUTO U T
A V 4 I
N
A V 4 I N
S VIDEO VIDEO R-AUDIO-L
P R P B Y
10BASE-T/
100BASE-TX
DIGITAL DIGITAL AUDIO OUT AUDIO OUT
(PCM/BITSTREAM) (PCM/BITSTREAM)
HDMI AV OUT
HDMI IN
Television’s rear
panel
HDMI cable
This unit’s rear panel
[Required]setting]
≥Set “HDMI Video Mode” and “HDMI Audio Output”
to “On” ( ➡ 85).
(The default setting is “On”.)
S
T
EP
1
C
o
nne
c
tion
DMRXW300GN-RQT9135-L_eng.book 17 ページ ２００８年４月３０日 水曜日 午後６時１１分