Panasonic P2HD AG-HPG20P - Manual (Page 34)


Up to four sets of settings can be saved as four
files on the SD card, and they can be loaded from
the card.
The menu setting value on the thumbnail display
screen cannot be saved or loaded.
1
Insert the SD card to the SD card slot.

Press [THUMBNAIL/MODE] to display the
normal display screen.

Press [MENU/MODE CHK].

Select “USER FILE” on the setting menu
“CARD FUNCTIONS”, select “CHANGE”,
and press .
Basic operations on the setting menus (Page 88)
CARD FUNCTIONS
PUSH MENU TO EXIT
SD CARD FORMAT
USER FILE RETURN
CHANGE
5
Select “FILE SELECT”, and press .
6
Using or , select the file number (1 to ),
and press .
USER FILE (SD CARD)
FILE SELECT
READ
WRITE
FILE 1
FILE 2
FILE 3
FILE 4
>>>
>>>
1
TITLE1
TITLE2
TITLE3
TITLE4
>>>
TITLE RELOAD

Using and , select “WRITE”, and press .
USER FILE (SD CARD)
FILE SELECT
READ
WRITE
FILE 1
FILE 2
FILE 3
FILE 4
>>>
TITLE2
TITLE3
TITLE4
>>>
TITLE RELOAD
1
RETURN
CHANGE

Display “YES” using and , and press .
In the figure below, “TITLE1” is the filename.
After the data has been saved, “WRITE OK”
is displayed.
The USER file which was written changes to
a white display.
WRITE FILE 1
NO
TITLE EDIT
TITLE1
USER FILE (SD CARD)
YES - - - - PUSH SET
•
•
•
•
•
Saving USER files on SD cards

Press [MENU/MODE CHK] four times to
display the normal display screen.
To give titles to files
1) Perform steps 1 to 7.
2) Select the characters using and , and
move to the next character using .
The number of characters which can be input
is 8.
Any of the following characters can be input.
(Space), A to Z, 0 to 9, : ; < = > ? @ [ \ ] ^ _ -. /
All the characters can be deleted using the
unit’s [RESET] button.
3) After all the characters have been input, press
at the left end of the characters (or at the
right end), display “YES” using , and press .
After the data has been saved, “WRITE OK”
is displayed.
To load a file
1) Perform steps 1 to 6.
2) Move to “READ” using and , display “YES”,
and press .
The files are loaded.
3) If “TURN POWER OFF” appears after loading,
turn off the power, and then turn it back on. The
loaded files are now set.
To reload the files from the SD card:
1) Perform steps 1 to 4.
2) Using and , move to “TITLE RELOAD”,
display “YES”, and press .
The files are now re-loaded.
If “WRITE NG FORMAT ERROR” is displayed,
format the SD card. (Page 33)
If “WRITE NG WRITE PROTECT” is displayed,
release the SD card protection.
If “WRITE NG CANNOT ACCESS” is displayed,
complete the other operations (such as playback),
and then proceed to operate.
If “WRITE NG ERROR” is displayed, the SD card
may be defective. Replace the card.
•
•
•
•
•
•
•
•
•
•