Panasonic DMC-FX50 - Manual (Page 106)

Others
106
VQT0Y19
[MOTION RECORDING WAS
CANCELLED DUE TO THE LIMITATION
OF THE WRITING SPEED OF THE
CARD]
• When you set the picture quality to
[30fpsVGA] or [30fps16:9], we
recommend using a high speed SD
Memory Card with “10MB/s” or greater
displayed on the package.
• Depending on the type of SD Memory
Card or SDHC Memory Card, recording
may stop in the middle.
[A FOLDER CANNOT BE CREATED]
A folder cannot be created because there
are no remaining folder numbers that can
be used. (P93)
Format the card after saving necessary
data on a PC etc. (P91)
If you execute [NO.RESET] in the [SETUP]
menu after formatting, the folder number is
reset to 100. (P21)
[PICTURE IS DISPLAYED FOR 4:3 TV]/
[PICTURE IS DISPLAYED FOR 16:9 TV]
• The AV cable is connected to the camera.
Press [MENU/SET] if you want to delete
this message at once.
• Select [TV ASPECT] in the [SETUP]
menu to change the TV aspect. (P22)
• This message also appears when the
USB connection cable is connected to the
camera only.
In this case, connect the other end of the
USB connection cable to a PC or a printer.
(P92, 95)
Troubleshooting
If you return the menu settings to the initial
settings at the time of purchase, the
condition may improve.
Select [RESET] in the [SETUP] menu.
(P21)
w Battery and power source
1: The camera cannot be operated even
when it is turned on.
• Is the battery inserted correctly?
– Check the direction of the battery.
(P14)
• Is the battery sufficiently charged?
– Use a battery that has been
sufficiently charged.
2: The LCD monitor turns off while the
camera is turned on.
• Is power save mode (P20) or economy
mode (P20) activated?
– Press the shutter button halfway to
cancel these modes.
• Is the battery exhausted?
– Use a battery that has been
sufficiently charged.
3: The camera turns off immediately
after it is turned on.
• Is the battery charge insufficient to
operate the camera?
– Use a battery that has been
sufficiently charged.
– If you leave the camera on, the
battery will be exhausted. Turn the
camera off frequently by using power
save mode (P20) etc.