Panasonic DMC-FX50 - Manual (Page 47)

Advanced
47
VQT0Y19
Taking Pictures using
Burst Mode
1 Press and hold the burst mode
button.
2 Move / to select a mode.
• You can also press the burst mode
button to select.
3 Press [MENU/SET].
• You can also press the shutter
button halfway to finish.
• The menu screen disappears after
about 5 seconds. At this time, the
selected item is automatically set.
4 Take a picture.
• Hold down the shutter button fully to
activate the burst mode.
w Number of pictures recorded in burst
mode
_1 The burst speed is constant regardless
of the transfer speed of the card.
• The number of pictures indicated is when
the shutter speed is faster than 1/60 and
the flash is not activated.
• If you set the ISO sensitivity (P73) to
[ISO400], [ISO800] or [ISO1250] and then
take pictures using burst mode, burst
speed will become slower than the figures
indicated above.
• Since the shutter speed becomes slower
in dark places, the burst speed (pictures/
second) may also become slower.
• In simple mode [ ], the settings become
as follows. [ ] appears on the screen.
(P26)
– [ ENLARGE]:
/Max. 6 pictures
– [ 4 SM6S/10M15cm]/[ E-MAIL]:
/Max. 8 pictures
• When the burst mode setting is set to
Unlimited
– You can take pictures until the capacity
of the card is full.
– The burst speed will become slower
halfway. The burst speed of a
MultiMediaCard becomes even slower
than that of an SD Memory Card or
SDHC Memory Card. However, the
exact timing of this depends on the
number of recordable pictures and the
card.
3
BURST SHOOTING
HIGH SPEED
LOW SPEED
UNLIMITED
OFF
SET SELECT MENU
Burst speed
(pictures/
second)
Number of recordable
pictures (pictures)
3 _ 1
max. 6 max. 8
2 _ 1
approx. 2
Depends on the remaining
capacity of the card.