Perle Systems P840 - Manual (Page 27)

Event Logs
27
Restoring boot DNLDSEG configuration
Generated upon entering Network Load Mode to initialize specific configuration information required for
retrieving new code image. Generated upon entering operational after a successful code burn into flash.
Restoring boot EEPROM configuration
Generated when restoring values in EEPROM configuration, this occurs when entering a load or operational
mode.
Running in System Load mode
Generated when the bridge/router is starting in System Load (Boot) mode. This is the mode for software
upgrades. Once the software upgrade has been successfully completed, the bridge/router restarts in
Operational mode.
Running in OPERATIONAL mode
Generated when the bridge/router is starting in Operational mode. This is the mode for normal operations
of the bridge/router.
Starting BACP negotiation with <remote site alias>
Generated when the Bandwidth Allocation Control Protocol negotiation has been initiated with the remote
site device associated with the stated remote site profile.
Starting BCP negotiation with <remote site alias>
Generated when the Bridging Control Protocol negotiation has been initiated with the remote site device
associated with the stated remote site profile.
Starting CCP negotiation with <remote site alias>
Generated when the Compression Control Protocol negotiation has been initiated with the remote site device
associated with the stated remote site profile.
Starting CMCP negotiation with <remote site alias>
Generated when the Connection Management Control Protocol negotiation has been initiated with the
remote site device associated with the stated remote site profile.
Starting IPCP negotiation with <remote site alias>
Generated when the Internet Protocol Control Protocol negotiation has been initiated with the remote site
device associated with the stated remote site profile.