Perle Systems P840 - Manual (Page 31)

Event Logs
31
* DHCP server – out of addresses in IP pool
Generated when the last address from the DHCP IP Address pool has been assigned to a device.
* Download aborted – Incomplete file
Generated when a TFTP download is aborted before the file transfer is complete
* Download aborted – Invalid FCS
Generated when there is a checksum failure after a file download.
* Download aborted – Incompatible boot code
Generated when the operating code file downloaded is incopatible with the boot code in this device. The updated
boot code software must be loaded before the operating code can be updated.
* Download aborted – Incompatible software
Generated when the software downloaded is incompatible with this device
* Download configuration too large
The configuration file that is being downloaded will not fit in the memory of this router
* E-mail server added to firewall
The IP address of the E-mail server added to the table of services available through the firewall.
* E-mail server removed from firewall
The IP address of the E-mail server removed from the table of services available through the firewall.
* Erasing config. block: starting
Generated as a notification that the configuration of this device is being erased from non-volatile memory prior to
loading a software update.
* Error loading configuration
Generated during a warm start when an error is detected while restoring a configuration from non-volatile
RAM.
* Feature upgrade failure, try again
Generated when the device detects a checksum error for the feature upgrade block.
* File copy failed: file crc: X, verify crc: X
Generated when performing a code upgrade and the calculated CRC was found to be different from the
transferred CRC (flash.fcs) value.