Perle Systems P840 - Manual (Page 29)

Event Logs
29
Alarm logs:
* Bad internal block checksum detected
Generated when power up diagnostics finds a fault in the internal block of the EEPROM.
* Closing remote site X (call limit)
Generated when the specified number of calls has been exceeded.
* Closing remote site X (callback failure)
Generated when the remote site interpreted the call sequence as a callback. However, a callback was not
completed in the expected time frame.
* Closing remote site X (force disconnect)
Generated when the connection to a remote site is being closed due to a force disconnect.
* Closing remote site X (inactivity)
Generated when the connection to a remote site is being closed due to an inactivity timeout.
* Closing remote site X (IP triggered RIP)
Generated when the connection to a remote site is being closed due to failure of IP triggered RIP.
* Closing remote site X (last session)
Generated due to the termination of the last session.
* Closing remote site X (link disabled)
Generated due to the link being disabled by the operator.
* Closing remote site X (no NCPs open)
Generated when no Network Control Protocols operating.
* Closing remote site X (nonexistant)
Generated when remote site being deleted by the operator.
* Closing remote site X (not enabled)
Generated when remote site autocall being disabled by the operator.
* Closing remote site X (resumption failure)
Generated due to failure to resume a suspended connection.
* Closing remote site X (scheduled down)
Generated due to time-of-day schedule deactivation of the connection.
* Closing remote site X (suspension timeout)
Generated due to reaching maximum time that the connection may be suspended.