Perle Systems P840 - Manual (Page 38)

Event Logs
38
* Running in System Load mode
Generated when entering System Load Mode in preparation for a download of code to be burned into flash.
* SECURITY ALERT: SNMP community <X> has write access enabled to “ALL” hosts
The SNMP community displayed has had write access enabled to all hosts on the network; anyone may access any
host to make changes.
* Service added to firewall
The IP address of the Service added to the table of services available through the firewall.
* Service removed from firewall
The IP address of the Service removed from the table of services available through the firewall.
* Telnet server removed from firewall
The IP address of the Telnet server removed from the table of services available through the firewall.
* Telnet server added to firewall
The IP address of the Telnet server added to the table of services available through the firewall.
* TFTP: Abort. ACK retry exceeded
Aborted a TFTP session because the bridge/router did not receive a new data packet within the TFTP “T1”
times “N2” interval.
* TFTP: Abort. ACK timeout
Aborted a TFTP session because the bridge/router did not receive an ACK for the last data packet it sent
within the TFTP “T1” times “N2” interval.
* TFTP: Abort. Error (#) received
Aborted a TFTP session because of the reception of a TFTP error message from the connected device. The
errors are: 0 - not defined, 1 - file not found, 2 - access violation, 3 - disk full or allocation exceeded, 4 -
illegal TFTP operation, 5 - unknown transfer ID, 6 - file already exists, 7 - no such user.
* Unable to allocate memory for DHCP server save
Generated when the memory on this device has become too fragmented to find a contiguous block of memory large
enough for the DHCP server tables. Reset the device to defragment memory.
* Unable to bind UDP Boot P client port
Generated as a result of an internal device error. Try resetting the device. If this is unsuccessful, contact a
service representative.