Panasonic BT-LH1760E - Manual (Page 22)

22
Main Menu
(continued)
Underlined values indicate factory defaults.
*1 When the monitor is shipped, settings for “USER1” - “USER5” are identical to “FACTORY.”
*2 “H-POSITION”, “V-POSITION”, “PHASE” and “CLOCK” (
J page 31) cannot be saved or loaded.
*3 Double speed reduces image lag caused by black signal input but lowers resolution compared to standard
speed and some images may generate flicker. Return to standard speed should flicker become noticeable.
*4 ITU-709 is an ITU-R BT.709 standard.
*5 Factory preset settings are The U.S.A. and Canada: SMPTE-C, Others: EBU.
SYSTEM CONFIG
Sub menu Settings Description
CONT./BACK.
BACKLIGHT
CONTRAST Selects function to be assigned to [CONTRAST/BACKLIGHT] (front panel
knob).
<BACKLIGHT> Adjusts the BACKLIGHT.
<CONTRAST> Adjusts the CONTRAST.
BACKLIGHT 0 - 60 Adjusts LCD backlight brightness. Adjust as required by ambient
conditions.
SUB WINDOW FULL
PART Selects sub-window type.
<FULL> Reduces the entire images for both input signals and places them
side by side.
<PART> Cuts out the center of the images for both input signals and places
them side by side (the images are shown at their original size).
MENU
POSITION CENTER
LB
RB
RT
LT Positions the on-screen menu.
<CENTER> Center of the screen
<LB> Left Bottom
<RB> Right Bottom
<RT> Right Top <LT> Left Top
STATUS
DISPLAY CONTINUE
3SEC OFF
OFF Sets display state for input signal status (on-screen menu).
<CONTINUE> Displayed at all times
<3SEC OFF> Displayed for 3 seconds after a status change.
<OFF> Not displayed.
SETUP LOAD
USER5
*1*2
USER4
*1*2
USER3
*1*2
USER2
*1*2
USER1
*1*2
FACTORY
Loads saved factory defaults (FACTORY) or user data (USER1 - USER5).
After loading user data, the screen displays the signal selected before
user data was loaded.
SETUP SAVE USER5
*2
USER4
*2
USER3
*2
USER2
*2
USER1
*2
Up to 5 sets of user data can be saved ( J page 16).
They save menu settings and adjustments made with the picture adjusting
knob (PHASE/CHROMA/BRIGHT/CONTRAST/BACKLIGHT) except
“SETUP SAVE/SETUP LOAD.”
POWER ON
SETUP USER5
USER4
USER3
USER2
USER1
FACTORY
LAST Selects the settings used when the power is turned on.
<LAST> Starts in the mode used when the power was last turned off.
<FACTORY> Starts up using the factory defaults.
<USER1 - 5> Starts up using USER registered settings.
COLOR SPACE SMPTE-C
*5
EBU
*5
ITU-709
*4
Sets the studio standard color shade.
POWER SAVE
MODE OFF
ON Sets the power save mode
<ON> The backlight dims when no signal (NO SIGNAL) is input for 60
seconds or longer. Signal input or menu operation will return the
backlight to its normal brightness.
BLACK DATA
INSERTION OFF
ON Doubles the speed of the LCD panel.
*3
<ON> Double speed (120 Hz/100 Hz)
<OFF> Standard speed (60 Hz/50 Hz)