Panasonic BT-LH1760E - Manual (Page 27)

27
Main Menu
(continued)
■ “PIXEL TO PIXEL” and “PIXEL POSITION”
The “PIXEL TO PIXEL” function allows you to check images at their actual pixel resolution (1080I/P signals only).
Press the button ([FUNCTION1] to [FUNCTION5] (
J page 23)) to which the “PIXEL TO PIXEL” function has
been assigned to turn the function on. Then press the button ([FUNCTION1] to [FUNCTION5] (
J page 23)) to
which the “PIXEL POSITION” function has been assigned to position the display of signals. (This assumes that
the “PIXEL TO PIXEL” and “PIXEL POSITION” functions have been assigned to any of the [FUNCTION1] to
[FUNCTION5] buttons.)
Underlined values indicate factory defaults.
*1 The following settings are disabled in PIXEL TO PIXEL mode.
Setting “ANAMO” to “ON”, and setting “SCAN” to “UNDER” in “VIDEO CONFIG”
Any “HV DELAY” setting in “FUNCTION”
“MARKER” display
*2 Enabled during “SDI1”, “SDI2” and “YP
B
P
R
” input.
■ “PIXEL POSITION” display position sequence
PIXEL POSITION:
➀
J
➁
J
➂
J
➃
J
➄
J
➀
…….
Sub menu Settings Description
PIXEL TO PIXEL
*1*2 OFF
ON Tailors the image display size to the input signal size.
Compatible formats
1080/60I/59I/50I/60P/59P/50P/30P/29P/25P/24P/23P/24Psf/23Psf
PIXEL POSITION CENTER
LEFT TOP
RIGHT TOP
RIGHT BOTTOM
LEFT BOTTOM Positions the display of signals in PIXEL TO PIXEL mode.
<CENTER> Center of the screen
<LT>
Left Top
<RT> Right Top
<RB> Right Bottom
<LB> Left Bottom
➀
CENTER
➁
LEFT TOP
➂
RIGHT TOP
➃
RIGHT BOTTOM
➄
LEFT BOTTOM