Panasonic BB-HCM381A - Manual (Page 122)

Operating Instructions
122
7. Set the image buffer frequency, and click [Next>].
fif
• Clicking [<Back] takes you back to the previous page.
• Clicking [Cancel] takes you back to the Trigger page without saving
changes.
Note
• Due to the network environment, object, the number of simultaneous
access, enabling IPsec or SD memory recording, the camera may not
record number of images that you set. In this case, set the image buffer
frequency longer.
• Set Every [1 s], buffer [1] images for the SD memory recording.
Image Quality • Select the image quality.
[Favor Clarity] optimizes for good quality.
[Standard] offers standard quality.
[Favor Motion] optimizes for enhanced motion.
[Mobile Phone] is for a transfer to a cell phone.
Note
• 640 × 480 pixels cannot be set for a transfer to a cell
phone.
Setting Description
Enable Pre-trigger
Image Buffer • Check the box to enable the setting. The camera
buffers or transfers the image right before the motion
detection signal is detected.
• Set an interval, number of images to buffer and total
number. The number of buffered images may not
match the total number (see page 191) due to memory
capacity, image resolution, image quality or what object
you view.
Setting Description