Patton electronic G.SHDSL INTEGRATED 3086 - Manual (Page 92)

4 • Basic Application Configurations Model 3086 G.SHDSL Integrated Access Device User Guide
92 DSLAM Connections with remote CPE units
5. Go to G.SHDSL in the Configuration Menu, then the submenu Status. The Modem State should be
“deactivated.” (If not, go to the Action and change it to deactivate.)
Then in the Action submenu under G.SHDSL, change Action to Start, then click on Action .
Model 3086 (Central) Configuration Steps (PPPoH Routed)
From the command line interface (CLI) via the RS-232 control port,
fi ip list interfaces
fi pppoh clear transports
One IP interface was called ip1 with an IP address of 192.168.1.1
Change the IP address so it is in the same subnet as the laptop PC. The laptop’s IP address is
192.168.172.229, so in this example, change the IP address of the 3086 to 192.168.172.3. The default IP
mask is 255.255.255.0.
fi ip set interface ip1 ipaddress 192.168.172.3 255.255.255.0