Panasonic WV-NS202 - Manual (Page 19)

19
Configure the basic settings of the camera [Basic setup]
The basic settings such as time and date and camera name, and the settings relating to the NTP server and the SD
memory card can be configured on the "Basic setup" page.
The "Basic setup" page has 3 tabs; the [Basic] tab, the [NTP] tab and the [SD memory card] tab.
Configure the basic settings [Basic]
Click the [Basic] tab on the "Basic setup" page. (
☞ page 15)
The settings such as the camera name, time and date, etc. can be configured on this page.
[Camera title]
Enter the title of the camera. Click the [SET] button after
entering the title of the camera. The entered title will be
displayed in the status display area.
Number of characters for the camera title: 0 - 20
characters
Default: WV-NS202
[Time & date setup]
Enter the current time and date. When "12-hours" is
selected for "Time display", "AM" or "PM" can be select-
ed.
Available range: 01/01/2006 0:00:00 –
12/31/2035 23:59:59
[Time display]
Select the time display format from "12-hours", "24-
hours" and "OFF". Enter the current hour reflecting this
setting when entering the current time and date for
"Time & date setup". To hide time and date, select
"OFF".
Default: 24-hours
[Date/time display format]
Select a date/time display format.
When "06/04/01 13:10:00" is set for "Time & date setup"
after selecting "24-hours" for "Time display", time and
date will be respectively displayed as follows.
DD/MM/YYYY: 01/04/2006 13:10
MM/DD/YYYY: 04/01/2006 13:10
DD/Mmm/YYYY: 01/Apr/2006 13:10
YYYY/MM/DD: 2006/04/01 13:10
Mmm/DD/YYYY: Apr/01/2006 13:10
Default: MM/DD/YYYY
[Daylight saving (Summertime)]
Select "ON" or "OFF" to determine whether or not to
apply daylight saving time. Select "ON" or "OFF" to
determine whether or not to apply daylight saving time.
ON: Applies summer time. An asterisk (*) will be dis-
played on the left side of the displayed time and
date.
OFF: Does not apply summer time.
Default: OFF
[Link/Access LED]
Select "ON" or "OFF" to determine whether or not to
light the link LED, the access LED, the SD memory card
error LED and the power LED.
Select "ON" to check the operational status by lighting
the LEDs. Select "OFF" to turn off the LEDs at all times.
Default: ON
Notes:
• Link LED: This LED will light when communication
with the connected device is available.
• Access LED: This LED will light when accessing a
network.