Panasonic WV-NS202 - Manual (Page 36)

36
Configure the settings relating to the preset positions ("Preset No." setup menu)
Click the [SETUP>>] button of "Preset Position" on the [Image/Position] tab of the "Camera setup" page.
(
☞ page 31)
It is possible to register, edit and delete the preset positions on this page.
When the focus, brightness, zoom factor are adjusted, the adjustment will be applied immediately to the currently
displayed image on the [Image/Position] tab.
Important:
When the zoom factor is 22x or more, the setting of the preset positions will become unavailable.
Depending on the environment (such as when the temperature is below +5 °C (41 °F), for example), the moving
speed of the camera to the preset position may become slower.
[Preset No.]
[SET] button: When the position of the camera is deter-
mined using the [ZOOM] buttons, the [FOCUS] but-
tons, the [BRIGHTNESS] buttons and the control
pad/buttons, click this button after selecting the
desired preset position number (1 - 64) from the pull-
down menu.
The determined position will be newly registered as
the preset position.
[DEL] button: When this button is clicked after select-
ing the preset position number to be deleted from
the pull-down menu, the preset position will be delet-
ed.
[GO] button: When this button is clicked after selecting
the preset position number from the pull-down
menu, the camera will move to the selected preset
position and the registration information will be dis-
played on the "Preset No." setup menu. Images from
the camera will be displayed on the [Image/Position]
tab.
Note:
When registering the preset position, the camera
may move slightly in the direction that the camera
moved last. This is a normal operation.
■ Position No.
[Preset ID]
Select "ON" or "OFF" to determine whether to enable or
disable the preset ID display. The preset ID display can
be applied to each preset position.
ON: Displays the preset ID.
OFF: Does not display the preset ID.
Default: OFF
Note:
When "ON" is selected, the entered preset ID will be
displayed at the position selected for "OSD Position"
on the [Basic] tab of the "Basic setup" page.
(
☞ page 20)
Important:
When "Preset ID (0-9, A-Z)" or "Preset ID" is edited,
it is necessary to click the [SET] button to apply
them.