Panasonic CQ-VA707N - Manual (Page 54)

55
CQ-VA707N
E
N
G
L
I
S
H
52
Electrical Connections
Cautions:
¡To prevent damage to the unit, be sure to follow the connection diagram as follows.
¡Remove about 5 mm of protective covering from the ends of the leads before connecting.
¡Do not insert the power connector into the unit until the wiring is completed.
¡Be sure to insulate any exposed wires to prevent a possible short-circuit from the car chassis. Bundle
all cables and keep cable terminals free from touching any metal parts.
!88 Display Unit/Control Unit
Connecting Cord
Control Unit (Rear)
Display Unit (Rear)
External Amplifier Control Power
Lead
(Green w/yellow stripe)
!7 Subconnector
!66 Ground Lead
!2 Power Connector
(White)
(Gray)
(Green)
(Violet)
(Left)
(Right)
(Left)
(Right)
(Fuse 10A)
(Resistor 220 Ω)
Dual CD Changer Control Lead
(Brown w/white stripe)
Front Speaker
Cord
Rear Speaker
Cord
(White w/black stripe)
(Gray w/black stripe)
(Green w/black stripe)
(Violet w/black stripe) –
–
–
–
AMP-CONT MAX0.1A
!6 Ground Lead
(Yellow)
(Red)
(Black)
(Blue w/white stripe)
ANT-CONT MAX0.1A
(Blue)
TV-CONT
(Blue w/red stripe)
TWIN CD • C-CONT
FRONT L
FRONT R
REAR L
REAR R
VIDEO-CONT
BATTERY 10A
ACC
Ground Lead
To a clean, bare metallic part of
the car chassis
TV Control Lead
To the power control lead of the
Panasonic TV tuner
Battery Lead
To the car battery, continuous
+12V DC
Navi Mute Lead
To the Navi Mute lead of the
Panasonic car navigation system
(for example, CN-DV2000EN)
Video Control Lead
To the Video Control lead of the
Panasonic car navigation system
(for example, CN-DV2000EN)
(Blue w/yellow stripe)
SIDE BRAKE
Reverse Lead
When connecting the rear view
camera, use the reverse lead.
(
a page 61)
Side Brake (Parking Brake)
Connection Lead
Be sure to wire the parking
brake for safety and preventing
accidents. (
a page 61)
Power Lead
To ACC power, +12V DC
(Orange)
NAVI MUTE
(Violet w/white stripe)
REVERSE
Antenna Control Lead
To the auto antenna control
power cord of the car
ILLUMINATION
(Orange w/white stripe)
Illumination Lead
To the power line connected to
the side lights of the car
+
+
+
+
Radio Antenna Connector
To a clean, bare
metallic part of
the car chassis
To a clean, bare
metallic part of
the car chassis
Basic System
❏ Connecting the Power Source
Notes:
¡This monitor system is designed only for use with a 12 volt DC motor vehicle.
¡Be sure to fully plug in the connectors.
¡Route the cord to avoid high-temperature spots and secure with clamps and tape.
¡When game devices are connected, the image may be unstable.
¡When removing the DIN plug, be sure to press the clip.