Panasonic DMR-ES30V - Manual (Page 25)

25
VQT0N92
Recording
[RAM] [-R] [-RW‹V›] [+R]
≥You can record up to 99 titles on a disc (49 titles [+R]).
≥It is not possible to record digital broadcasts that allow “One time
only recording” onto DVD-R, DVD-RW, +R or 8 cm (3 q) DVD-RAM
discs. Use a CPRM compatible DVD-RAM
≥Recording will take place on open space on the disc. Data will not
be overwritten.
≥If there is no space left on the recording disc, you will need to erase
unwanted titles ( l 22, 33) or use a new disc.
Preparation
≥Release protection (disc
l 30, cartridge l 30). [RAM]
≥Select an audio type you want to record. ( l right below)
≥Press [DVD].
[1] Press [ Í, DVD/VHS POWER] to turn the unit on.
[2] Insert a disc. ( l 8)
≥When using a DVD-RAM for the first time with the unit, format it
to ensure accurate recording ( l 31, “Format Disc”).
[3] Press [CH, W, X] to select the channel.
To select with the numeric
buttons:
Antenna Mode
(Airwaves)
e.g.,
“5”: [0] )[5]
“15”: [1] )[5]
CableTV Mode (Cable)
e.g.,
“5”: [0] )[0] )[5]
“15”: [0] )[1] )[5]
“115”: [1] )[1] )[5]
[4] Press [REC MODE]
to select the
recording mode
(XP, SP, LP or EP).
[5] Press [ ¥, REC] to
start recording.
≥You cannot change the
channel or recording
mode during recording.
You can change them
while recording is paused, but the material is recorded as a
separate title.
∫ To pause recording
Press [ ;, PAUSE]. (Press again to restart recording.)
≥Title is not split into separate titles.
≥You can also press [¥, REC] to restart recording.
∫ To stop recording
Press [ ∫, STOP].
≥Recorded as 1 title until the position where stopped.
≥It takes about 30 seconds for the unit to complete recording
management information after recording finishes. [-R] [-RW‹V›] [+R]
(Unit: hour)
≥Depending on the content being recorded, the recording times may
become shorter than indicated.
° When “Recording Time in EP Mode” has been set to “EP (6H)” in
the SETUP menu. ( l 43)
The sound quality is lower compared to other recording modes
when using “EP (8H)”.
Note
When recording to DVD-RAM using EP (8H) mode, play may not be
possible on DVD players that are compatible with DVD-RAM. In this
case use EP (6H) mode.
FR (Flexible Recording mode l 26):
≥You can set FR mode when transferring (dubbing) or programming
scheduled recordings.
[RAM]
Preparation
≥Press [DVD].
Press [AUDIO].
Stereo # SAP # Mono
^----------------------------}
≥If you change the sound setting while recording, the recorded
sound will also change.
[-R] [-RW‹V›] [+R]
Select the audio (Main or SAP) in “Select MTS” in
the SETUP menu.
( l 44)
Recording TV programs
∫ Recording procedures
When recording to DVD-R, DVD-RW (DVD-Video format) or +R
≥When recording MTS broadcasts
- If you do not connect a cable TV box
Select “Main” or “SAP” in “Select MTS” in the SETUP menu
(
l 44).
- If you connect a cable TV box
Select “Main” or “SAP” on the cable TV box.
≥The aspect ratio of the recorded image will be 4:3.
≥In order to play a DVD-R, DVD-RW (DVD-Video format) or +R
recorded using this unit on another playback source, the
disc must first be finalized (
l 31).
Remaining time on the disc
∫ Recording modes and approximate
recording times
DVD-RAM
DVD-R
DVD-RW
+R
(4.7 GB)
Single-sided
(4.7 GB)
Double-sided
(9.4 GB)
XP (High quality) 1 2 1
SP (Normal) 2 4 2
LP (Long play) 4 8 4
EP (Extra long play) 8 (6 ° ) 16 (12 ° ) 8 (6 ° )
Selecting audio to record
Stereo: Main audio (stereo). If the broadcast is “Mono _ SAP”,
audio will be monaural even if you select Stereo
mode.
SAP: Secondary audio program (SAP). If recorded in SAP,
main audio is also recorded.
Mono: Main audio (monaural). Select “Mono” if reception is
poor during a stereo broadcast.
EP (6H) °
EP (8H)
LP
SP
XP
Pict
ure q
ual
it
y
Recording time
CH 12
No disc
((Stereo
e.g., “Stereo” is selected.
“((” appears when the unit is receiving
the audio type you selected.
DVD
Pl
ay
ba
ck
Re
co
rd
in
g
ES30VP&PC.book 25 ページ ２００５年２月２１日 月曜日 午後２時３２分