Paxar 611 - Manual (Page 33)

Users Manual - 610/611/612 Printers Printing
••
29
Printing Serial Bar Codes
Currently, the 610 / 611 / 612 printer does not support printing serial (ladder) bar codes.
Parallel (Picket Fence) Bar Code Serial (Ladder) Bar Code
Adjusting Print Positions
You can adjust the supply, print, and margin positions by using the control panel
buttons. Make sure a batch is not waiting to print, the printer is not paused, or has an
error before you change the settings.
To change the supply, print, or margin positions:
1. Press Pause.
2. Press Feed and Clear (at the same time) once to select the supply position, twice to
select the print position, and three times to select the margin position. These
buttons act as toggle switches between the three (supply, print, and margin) position
adjustments.
When you select the position to change, the current setting
is displayed.
3. Press Feed to decrease the current position by one dot or press Feed for two
seconds to decrease the value by 10 dots.
OR
Press Clear to increase the current position by one dot or press Clear for two
seconds to increase the value by 10 dots.
If the position has a negative value, the supplies light is on.
After you adjust the position (and release the buttons), the
setting is displayed.
4. Press Pause when you are done making adjustments.