Philips 502-1040510 - Manual (Page 13)

13 Using your HD receiver
EN
G
LI
SH
4 Using your HD receiver
4.1 Standby/wake up
To put your HD receiver into standby, press
on your HD receiver’s front panel or remote
control. To take your HD receiver out of standby,
press again. You can also press BACK ,
P+/P- or any number button on your remote
control to wake up your HD receiver.
See page 6 for more information.
4.2 Switching on and off
Use the ON/OFF switch on the rear panel of
your HD receiver to switch your HD receiver
on/off. See page 6 for more information.
4.3 Changing channels
To change channels, use the P+/P- on your
remote control or your HD receiver’s front
panel. You can also use the number buttons on
your remote control.
Press BACK to switch to the last channel
you were watching.
You can also use the on-screen channel lists or
channel banner to change channels (see sections
4.5 and 4.6).
Note
Initially, HD programmes are available only on
channels 50 and 51. Switch to these channels to
watch HD programmes.
4.4 Adjusting volume
To increase or decrease the volume, press
VOL+/VOL-. The volume level is shown briefly
on your TV.
To mute or restore the sound, press . When
you mute your sound, the icon is shown
in the top right corner of your TV. This icon
disappears after a few seconds.
4.5 Using the channel banner
Channel information
When you change a channel, the channel banner
appears briefly to show information about the
current programme. By default, it appears for
5 seconds. To set the length of time that the
channel banner remains on-screen, see page 23.
Note
While recording a programme to an external
recording device such as a VCR, the channel
banner overlay will not be recorded.
Changing channel
To change the channel, display the channel
banner by pressing INFO.
When the channel banner is on-screen,
use / to see what programmes are
currently showing on other channels. If you
see a programme you want to watch,
press OK.
To display more information about the
current programme on the channel listed in
the channel banner, press INFO again.