Philips 502-1040510 - Manual (Page 26)

Using more of your HD receiver 26
Note
Resetting your HD receiver to the factory
default settings erases all of your preferences
and settings. For example, all of your favourite
lists and recording timers will be erased.
Changing other system settings
From the Settings menu, use / to
highlight Set-up and press or OK.
The Set-up menu appears.
To turn on or off the channel updates
that automatically happen when your HD
receiver is in the active-standby mode, make
sure Channel installation is highlighted
and press or OK. Press to highlight
Automatic update and press or OK.
Use / to highlight On or Off.
Press or BACK to save your changes
and return to the previous menu.
To check the signal quality of any channel
that you are receiving, press to highlight
Signal quality and press or OK.
In the Signal quality test menu that
appears, use / to select a channel that
you want to check. Press or BACK to
return to the previous menu.
To turn on or off powering your active-
indoor antenna using the Antenna IN
connector on the rear panel of your HD
receiver, press to highlight Antenna
powering and press or OK. Use / to
highlight Off or On.
Press or BACK to save your changes
and return to the previous menu.
Your HD receiver locates the software
available on your USB memory stick and
displays a confirmation message. Press
the green button to install the software
immediately. Press the red button to cancel
and return to the previous menu. If you
press the green button, your HD receiver
updates the software and restarts. You may,
depending on the update, then be required
to complete the first installation setup (see
page 10).
Restoring factory default settings
From the Settings menu, use / to
highlight Set-up and press or OK.
In the Set-up menu that appears,
use / to highlight Factory reset and
press OK twice.
A message appears asking you to confirm.
If you are sure, press the green button, or
press the red button to cancel and return
to the previous menu. If you press the
green button, your HD receiver restores
the factory default settings and restarts. You
will then be required to complete the first
installation setup (see page 10).