Philips 502-1040510 - Manual (Page 24)

Using more of your HD receiver 24
Default volume
Use this to set the default volume at wake-
up of your HD receiver.
Changing parental control settings
From the Settings menu, use / to
highlight Parental control and press or
OK . The Parental control menu appears.
To change the parental control severity settings,
use / to highlight Parental control limits,
and press or OK.
Use / to highlight the severity level you
want to set, and press or OK to save your
changes and return to the previous menu. Note
that if you set the Parental control limits to
Off , the child timers and channel lock settings
(see below) will not have any effect.
Note
When Parental control limits is set to
ON , menu items like Parental control and
Set-up will be protected by the PIN code.
To create a new child timer, use / to
highlight Child timers, and press or OK.
Make sure that Define child timer is
highlighted and press or OK.
• Audio capabilities on HDMI - Use this
to set the HDMI audio format to PCM
(default) or Auto*.
• Audio capabilities on S/PDIF - Use this
to set the S/PDIF audio format to PCM
(default) or Dolby Digital*. You can also
set this to Not connected.
• Easy Link mode - For future use.
• TV format - Use this to set the format
of the high-definition video that is output
on the HDMI connector of your HD
receiver. You can set this to 16/9 Pillar Box
(default), 16/9 Full Screen or 16/9 Zoom.
These options determine how standard
(4:3) programmes show on a TV with aspect
ratio of 16:9. Note that you can directly
change this setting using the picture
format button on your remote control.
* The Auto and Dolby Digital settings on
HDMI or S/PDIF are not recommended until
your HD receiver has been updated with the
appropriate software.
Visit www.philips.com/support regularly to
check if the relevant software update is available.
Automatic eco mode
Use this to set the time after which your
inactive HD receiver automatically enters
into the active standby mode. You can set
this to off, 3 hours (default), 4 hours,
5 hours, 6 hours , 7 hours or 8 hours.
Return channel
Use this to configure your HD receiver to
connect to the internet, which then serves as
a return channel to your Digital TV service
provider. The return channel is necessary to use
any interactive applications that your Digital TV
service provider may offer. Before configuring
the return channel, be sure to connect your
HD receiver to your network router using an
Ethernet cable. Then choose either DHCP
to set up your connection automatically or
manually enter all the parameters like IP
address , Network mask, Gateway and
DNS settings to match your router’s settings.