Panasonic KX-TG2563F - Manual (Page 60)

60
Before Requesting Help
Problem
You cannot program items,
such as the dialing mode.
Previously programmed
information is erased.
You cannot store a name
and phone number in the
directory.
While programming or
searching, the unit starts to
ring and stops the program/
search.
The unit does not display the
caller’s name and/or phone
number.
The display goes to the
standby mode while viewing
the Caller List.
When a second call is
received during a
conversation, the unit does
not display the new caller’s
name and/or phone number.
Remedy
•Programming is not possible while the unit
is in the talk or speakerphone mode or
when viewing the Caller List/directory list.
•Do not pause for over 60 seconds while
programming.
•Move closer to the base unit.
•Make sure that the unit is in the standby
mode.
•If a power failure occurs, programmed
information may be erased. Reprogram
if necessary.
•You cannot store an item in the directory
while the unit is in the talk,
speakerphone or intercom mode.
•Do not pause for over 60 seconds while
storing.
•To answer the call, press
(TALK) or
(DIGITAL!SP-PHONE) . Start again from
the beginning after hanging up.
•You need to subscribe to a Caller ID
service from a telephone company.
•Other telephone equipment may be
interfering with your phone. Disconnect
it and try again.
•Other electrical appliances connected to
the same outlet may be interfering with
the Caller ID information.
•Telephone line noise may be affecting
the Caller ID information.
•Do not pause for over 60 seconds while
searching.
•
(DIGITAL!SP-PHONE) was pressed.
•The line mode selection is incorrect. See
page 16.