Pride Mobility JET 3 - Manual (Page 22)

22 www.pridemobility.com Jet 3 Ultra
I V . A S S E M B L Y
Figure 10. Universal Mounting System
INITIAL ASSEMBLY
Your power chair may require some assembly either before initial use or after transportation. It may also require
disassembly to make some comfort adjustments.
NOTE: Any nylon insert lock nut removed during the disassembly or adjustment of the power chair must be
replaced with a new nut. Nylon insert lock nuts should not be reused as it may cause damage to the nylon insert,
resulting in a less secure fit. Replacement nylon insert lock nuts are available at local hardware stores or
through your authorized Pride Provider.
Seat Installation
It may be necessary to install the seat either prior to initial operation or after transporting your power chair. Most
seats are attached to the power base with the Universal Mounting System (UMS). The UMS consists of universal
parts that may be attached to any medium-back or high-back seat, regardless of seat width or seat depth. The two
main components are aluminum extrusions mounted to the seat base. These extrusions attach to a pair of trapeze
bars that are mounted to the power base.
WARNING! Do not pick up the seat frame by the armrests. They are free to pivot, and you may
lose control of the seat if they do so.
REAR TRAPEZE BAR
REAR EXTRUSION
FRONT EXTRUSION
SEAT LATCH
FRONT TRAPEZE BAR