Pride Mobility JET 3 - Manual (Page 24)

24 www.pridemobility.com Jet 3 Ultra
V . C O M F O R T A D J U S T M E N T S
COMFORT ADJUSTMENTS
After becoming familiar with your power chair’s operation, you may find the need to make some adjustments to
increase your comfort, such as seat height and angle, armrest angle, foot platform height and angle, and controller
position.
NOTE: If your power chair is equipped with a Specialty Seat, refer to the information provided in separate
manuals. If your power chair is equipped with a medium-back, a high-back, or a reclining seat, refer to the
following information.
WARNING! The center of gravity of your power chair was factory set to a position that meets the
needs of the demographic majority of users. Your authorized Pride Provider has evaluated your
power chair and made any necessary adjustments to suit your specific requirements. Do not
change your seating configuration without first contacting Pride Mobility Products or your
authorized Pride Provider.
WARNING! Some power chair components
are heavy. You may need assistance to lift or
carry them. Please refer to the specifications
table for specific component weights before
you disassemble the power chair.
WARNING! Remove the occupant from the
power chair before making any adjustments.
You may need the following to make comfort adjustments:
metric/standard socket set and ratchet
adjustable wrench
thread lock
Seat Height and Seat Angle Adjustment
The seat is attached to the power base through the UMS. You
can change the seat height to one of two positions by raising
the front and rear trapeze bars. If you raise or lower only one
trapeze bar (front or rear), you can also change the seat base
angle (dump).
To change the seat height:
1. Turn off the power to the controller.
2. Loosen the rear shroud fasteners and remove the rear
shroud. See figure 6.
3. Disconnect the controller connectors from the power
module.
4. Flip up the seat latch safety. See figure 13.
5. Squeeze the seat latch and release the seat from the front
trapeze bar.
6. Slide the seat forward and remove it from the power base.
7. Loosen the screws that attach the trapeze bars to the seat
posts. See figure 14.
8. Remove the retaining clips that secure the seat posts to
the power base. See figure 14.
9. Move the trapeze bars up or down to the desired height.
Figure 13. Seat Latch Safety
Figure 14. Trapeze Bar Adjustment
SCREWS
SEAT POSTS
TRAPEZE BARS
RETAINING CLIPS