Appendix i - specifications – Pride Mobility JET 3 User Manual
Page 45
Jet 3 Ultra
www.pridemobility.com
45
A P P E N D I X I - S P E C I F I C A T I O N S
1
Varies with base model, user weight, terrain type, battery amp-hour rating (Ah), battery charge, battery condition, motors, controller
type, tire type, and tire condition. This specification can be subject to variance of (+ or -) 10%.
2
Due to manufacturing tolerances and continued product improvement, this specification can be subject to variance of (+ or -) 3%.
3
Tested in accordance with ASNI/RESNA, WC Vol 2, Section 4 & ISO 7176-4 standards. Results derived from theoretical calculations
based on battery specifications and drive system performance. Test conducted at maximum weight capacity.
4
AGM or Gel-Cell type required. See VI. “Batteries and Charging.”
5
Battery weight may vary based on battery manufacturer.
NOTE: This product conforms to all applicable ANSI/RESNA testing requirements and ISO 7176 series
EN12184 standards. All specifications subject to change without notice.
JET 3 ULTRA SPECIFICATIONS
Suspension:
Active-Trac
Drive Wheels:
10 in. (25.4 cm) pneumatic or solid available
Caster Wheels:
8 in. (20.32 cm) solid, rear-mounted
Anti-tip Wheels:
6 in. (15.24 cm) solid, front-mounted
Maximum Speed:
1
Up to 4 mph (6.44 km/h)
Range:
1,3
Up to 11 miles (17.7 km)
Brakes:
“Intelligent Braking” electronic regenerative, disc park brake
Ground Clearance:
2
See figure 29.
Turning Radius:
2
See figure 29.
Overall Size:
2
Length: See figure 29.
Width: See figure 29.
Drivetrain:
Two motor, mid-wheel drive
Batteries:
4,5
Two 12-volt, deep-cycle, U-1
Battery Charger:
3-amp, off-board
Weight Capacity:
300 lbs. (136 kg)
Component Weights:
2
Base: 92 lbs. (41.74 kg)
Medium-back Seat: 37 lbs. (16.78 kg)
Batteries: 24.5 lbs. (11.11 kg) each