Pride Mobility JET 3 - Manual (Page 27)

Jet 3 Ultra www.pridemobility.com 27
SETSCREW
V . C O M F O R T A D J U S T M E N T S
Controller Position
You can move the controller in toward or out away
from the armrest, or change the position of the control-
ler for either left-hand or right-hand use.
WARNING! Do not place the controller
harness so that it can be pinched in the
seat frame or the power base frame.
To extend the controller:
1. Flip up the armrest so it is perpendicular to the
floor.
2. Loosen the setscrew on the controller bracket. See
figure 18.
3. Slide the controller into or out of the armrest to the
desired position.
4. Tighten the setscrew to secure the controller.
To change the controller position:
1. Turn off the power to the controller.
2. Loosen the rear shroud fasteners and remove the
rear shroud. See figure 6.
3. Unplug the controller connectors from the power
module. See figure 7.
4. Cut the wire ties that attach the controller harness
to the armrest.
5. Flip up the armrest and loosen the setscrew. See
figure 18.
6. Slide the controller out of the armrest.
7. Loosen the setscrew in the other armrest.
8. Place the controller in the other armrest.
9. Tighten the setscrew to secure the controller.
10. Use wire ties to secure the controller harness to the
armrest. See figure 12.
11. Plug the controller connectors into the power pod.
See figure 7.
12. Reinstall the rear shroud and tighten the fasteners.
Figure 18. Underside of Armrest