Pride Mobility JET 3 - Manual (Page 30)

30 www.pridemobility.com Jet 3 Ultra
Elevating Leg Rests
Elevating Leg Rests (ELRs) offer an infinite range of adjust-
ment for the leg angle.
To rotate the ELRs:
1. Push in release lever A.
2. Rotate the ELRs.
To adjust the angle on standard ELRs:
1. Push down release lever B. See figure 23.
2. Move the leg rest to the desired angle.
To adjust the ELR length:
1. Remove the two adjustment screws from the side of each
leg rest extension. See figure 23.
2. Slide the leg rest up or down to the desired length.
3. Reinstall the two adjustment screws.
Anti-Tip Wheels
The anti-tip wheels are designed to give your power chair
increased stability on rough surfaces. The anti-tip wheels
are preset at the factory for smooth surfaces or indoor use
only. If you plan on using your power chair on rough sur-
faces, it may be necessary to adjust the anti-tip wheels to
better suit your needs. The anti-tip wheels may need adjust-
ment if the following occurs:
When coming to a stop, your power chair tips forward excessively.
The anti-tip wheels constantly rub the ground.
WARNING! Consult your authorized Pride Provider before attempting to change the anti-tip
wheel height! Changing the anti-tip wheel height affects handling under acceleration!
WARNING! The higher you raise the anti-tip wheels, the more you increase your power chair’s
tendency to tilt forward while decelerating. You can compensate for this by having your
authorized Pride Provider make a small adjustment to the pre-programmed deceleration setting
in the controller or by moving the seat assembly farther to the back of your power chair.
PROHIBITED! Do not remove the anti-tip wheels.
NOTE: Each pneumatic drive tire must be inflated to the psi/bar/kPa air pressure rating indicated on the tire
in order for the anti-tip wheels to be properly adjusted.
V . C O M F O R T A D J U S T M E N T S
Figure 23. Elevating Leg Rests
RELEASE LEVER A
RELEASE LEVER B
LEG REST EXTENSION ADJUSTMENT
SCREWS