Precor C764 - Manual (Page 36)

page 36
C O M M E R C I A L P R O D U C T S D I V I S I O N
Because of its advanced design, the C764 climber requires little maintenance
beyond periodic cleaning, which is explained in this section. Keep in mind that,
as owner of this machine, you are solely responsible for its maintenance.
DANGER —
INSPECTION
Perform a daily inspection of the C764. Look and listen for slipping belts, loose
fasteners, unusual noises, worn or frayed power cords, and any other indications
that the equipment may be in need of service. Obtain service should you notice
Important: If you determine that the C764 is in need of service, move it away from
the main workout area and place an large “Out of Service” sign on it.
To order parts or to contact a Precor authorized service provider in your area,
refer to
Obtaining Service on page 7.
ACCESSING THE SOFTWARE VERSION NUMBER AND ODOMETER
At the start-up prompt, press and release the WORK LEVEL/SPEED ▼▲ keys
simultaneously to find out what software version number you have and determine
the total number of floors climbed.
A software version number such as 1.05 appears in the display. Press ENTER
and the total number of floors climbed appears. Multiply that number by 10 to
determine the actual number of feet climbed. Press ENTER and the start-up
prompt appears.
CLEANING THE EQUIPMENT
Most of the working mechanisms are protected inside the casing. However, for
efficient operation, the C764 relies on low friction. To keep the friction low, the
C764 pedals and internal mechanisms must be as clean as possible.
• To clean all exposed surfaces on the C764, it is recommended that you use
a diluted solution of mild soap. Clean the C764 everyday with a soft cloth,
dampened (not dripping wet) in the solution.
CAUTION: Do not use any acidic cleaners. Doing so will weaken the
unit’s coating and void the Precor Limited Warranty. Never pour water
or spray liquids on any part of the C764. Allow the C764 to dry
completely before using.
• Periodically, clean the grooves on the foot pedals using a soft nylon scrub
brush. Vacuum the floor underneath the unit to prevent the accumulation of
dust and dirt.
• The Precor Heart Rate equipment requires little maintenance beyond keep-
ing it dust free. Dampen a sponge or soft cloth in mild soap and water to wipe
the touch-sensitive grips on the handlebar or to clean the POLAR
® chest
strap. Dry the surface thoroughly with a clean towel.
Maintenance
To reduce the risk of electrical shock, always unplug
the unit from its power source before cleaning it or
performing any maintenance tasks.