Precor 100i - Manual (Page 12)

Club Features
These next few pages explain how to customize the equipment for
your club or facility and view useful product information. All these
features remain hidden to the patrons and can only be accessed
using special key presses. Read this section if you want to:
y
y
y
y
y
y
y
y
y
y
y
y
y
Change the display to a different language
Change the display to show U.S. standard or metric
measurements
Set the maximum exercise and pause times
Set a cool-down time limit
View the odometer
Display the number of hours the equipment has been in use
View the software versions and part numbers
Display the serial number
Check the program usage and error logs
Note: To review the club programming prompts and factory
default settings that can be changed through club programming
mode, refer to the following table.
Club Programming Tips
Always start at the Precor banner.
Electrical power must be supplied. For self-powered equipment,
a constant power source is available if you use the optional
power adapter, otherwise you will have to maintain the minimum
rate of motion. Refer to Self-Powered Features. If you plan to
program self-powered equipment, purchasing the optional
power adapter is highly recommended.
Note: If you do not use the optional power adapter during club
programming mode, and the rate of motion falls below the
minimum requirements, no warning is given when the equipment
moves into its 30-second shutdown procedure.
The club programming mode is accessed by pressing the
RESET key at the Precor banner. The remaining key presses
must occur quickly and without pause.
Note: Keys that can be used interchangeably in club
programming mode are OK and ENTER.
The changes made in club programming mode become the
default settings whenever the display resets to the Precor
banner.
Product Owner's Manual: Club Features 10