Superimpose screen, Time code/user bit (continued) – Panasonic AJ-SD255 User Manual
Page 36
36
Time code/user bit (continued)
Superimpose screen
The control signals, time code, etc. are displayed using
abbreviations.
TCR
:
:
:
TCR
:
:
:
TCR
:
:
:
Abbreviations:
CTL : Control signal count value
TCR : Time code data recorded in the SBC area
TCR. : Time code data recorded in the VAUX area
UBR : User bit data recorded in the SBC area
UBR.: User bit data recorded in the VAUX area
TCG : Time code data of the time code generator
UBG : User bit data of the time code generator
Characters displayed
The background of characters superimposed on the display can be
changed using setup menu No. 011 (CHARA TYPE).
TCR
:
:
:
TCR
:
:
:
Display position
The position of the characters superimposed on the display
can be changed using setup menus No. 009 (CHARA H-
POS) and No. 010 (CHARA V-POS).
TCR
STOP
:
:
:
Operation mode
The VTR’s operation mode can also be displayed using
setup menu No. 008 (DISPLAY SEL).
TV monitor
TV monitor
TV monitor
TV monitor
TV monitor
TV monitor
VTR operation mode
INT
(REGEN/
PRESET)
EXT
TCG switch
– – –
LTC
VITC
Setup menu
No. 505
EXT TC SEL
Setup menu
No. 514
VITC GEN
Selected video input
signal
OFF
Internal TCG value
Timecode on IEEE1394
digital input (VAUX area)
VITC on input video signal
3
Timecode from TIME CODE
IN connector input
1
Timecode on IEEE1394
digital input (VAUX area)
VITC on input video signal
3
Timecode on IEEE1394
digital input (VAUX area)
VITC on input video signal
3
Timecode on IEEE1394 digital input (SBC area)
VITC on input video signal
2
Timecode on IEEE1394
digital input (SBC area)
VITC on input video signal
2
SBC area
VAUX area
Recorded timecode
Internal TCG value
Timecode from TIME CODE IN connector input
1
Timecodes recorded by this product
1: The internal TCG value is used when the signal cannot be detected from the TIME CODE IN connector input.
2: The internal TCG value is used when the VITC cannot be detected on the input video signal.
3: Nothing is recorded if the VITC cannot be detected on the input video signal.
– – –
ON
OFF
OFF
1394
Y P
B
P
R
/S-VIDEO/
CMPST/SDI
1394
Y P
B
P
R
/S-VIDEO/
CMPST/SDI
1394
Y P
B
P
R
/S-VIDEO/
CMPST/SDI
1394
Y P
B
P
R
/S-VIDEO/
CMPST/SDI
ON
– – –
ON
Note:
[T
R], [T
R.], [U
R] or [U
R.] is displayed when
the data has not been read correctly from the tape.