Panasonic KX TG2382PW - Manual (Page 66)

66
Troubleshooting
Problem
“No link to base
Move closer to
base, try again ” is
displayed and an alarm
tone sounds.
Static, sound cuts in/out,
fades. Interference from
other electrical units.
The handset does not ring.
The handset display is
blank.
You cannot store a name
and phone number in the
directory.
While programming or
searching, the handset
starts to ring and stops the
program/search.
You cannot make an
internal/external call with
the handset.
Cordless Telephone
Cause & Remedy
•You are too far from the base unit.
Move closer to the base unit and try again.
•Plug in the AC adaptor of the base unit.
•Raise the base unit antenna.
•Locate the handset and the base unit away
from other electrical appliances (p. 6).
•Move closer to the base unit.
•Raise the base unit antenna.
•The ringer volume is OFF. Set to HIGH,
MEDIUM or LOW (p. 19).
•If more than one other user is using the
handsets and base unit, the handset may not
ring. Those users will hear incoming call
tones (p. 48) and the IN USE/HOLD indicator
flashes quickly on the base unit.
•Charge the battery fully (p. 10).
•You cannot store an item in the directory while
the handset is in the talk, speakerphone,
intercom or remote operation mode.
•Do not pause for over 60 seconds while
storing.
•To answer the call, press
or . Start
again from the beginning after hanging up.
•You cannot make a call when the handset is
in the remote operation mode. Exit the mode
by pressing
(OFF)
(p. 52).