Pioneer VSX-D2011-G - Manual (Page 114)

Techno Tidbits & Problem-solving
114
En
During playback of a
Surround EX or DTS ES
source on the AUTO setting,
the EX and ES indicators
won't light.
During playback of a DVD
audio source, the player
shows a transfer rate of 96
kHz, but the receiver does
not.
During playback of a 96 kHz
source, the display doesn't
show 96 kHz
Remote control
Cannot be remote
controlled.
Other components can't be
operated with the system
remote.
The SR cable is connected,
but the connected
components can't be
operated with the remote.
• The source may be 6.1 playback
compatible, but there is no signal from the
source to indicate this.
• The multichannel connections are analog,
so there is no digital transfer.
• SIGNAL SELECT is set to ANALOG
• The remote control batteries have worn
out.
• Too far away or improper angle of
operation.
• There is an obstacle between the
receiver and the remote control.
• Strong light such as fluorescent light is
shining onto the unit's remote control signal
light-receiving window.
• A cord is connected to the CONTROL IN
terminal on this unit.
• The IR Receiver type is mismatched with
the setting.
• The preset code settings are wrong.
• The batteries wore out and the system
settings were cleared.
• The SR cable hasn't been connected
properly.
• The rest of the component connection
have not been made.
• The component you have hooked up is
not SR compatible.
• Switch the SB CH MODE to ON (see
page 54).
• This is not a malfunction. See the
player's manual for more details.
• SET the SIGNAL SELECT to AUTO (see
page 45).
• Replace the batteries (see page 7).
• Operate within 7 m and a 30° angle of
the remote sensor on the front panel (see
page 8).
• Remove the obstacle or operate from
another position (see page 8).
• Avoid exposing the remote sensor on the
front panel to direct light.
• Connect cord to the correct jack.
• Disconnect the IR Receiver from the rear
panel, and set to the other IR Receiver type
using the remote control.
• Input the correct preset code.
• Reset the proper system settings.
• Reinsert the SR cable, making sure it is
the right jack (see page 79).
• Make sure an analog connection has
been made between the units.
• This is not a malfunction.
Symptom Cause Remedy
If the unit does not operate normally due to external effects such as static electricity
Disconnect the power plug from the outlet and insert again to return to normal operating conditions.
Maintenance of External Surfaces
• Use a polishing cloth or dry cloth to wipe off dust
and dirt.
• When the surfaces are dirty, wipe with a soft
cloth dipped in some neutral cleanser diluted five
or six times with water, and wrung out well, and
then wipe again with a dry cloth. Do not use
furniture wax or cleaners.
• Never use thinners, benzine, insecticide sprays
or other chemicals on or near this unit, since
these will corrode the surfaces.