Pioneer VSX-D2011-G - Manual (Page 26)

26
En
Connecting Your Equipment
Speaker impedance
You can change the speaker impedance for VSX-D2011 but we recommend using speakers with an
impedance of 8
Ω-16 Ω (the default setting). If you are using 6 Ω- less than 8 Ω impedance speakers, you
need to change the impedance setting. Use any speaker rated between 6
Ω-16 Ω.
First put the receiver in STANDBY mode, then
press the power button while holding down the
SPEAKERS button.
The receiver will re-set to the new impedance
setting. With this method you can choose the 8
Ω-
16
Ω setting or the 6 Ω-8 Ω setting.
To check which impedance setting
to hold down the SPEAKERS
button for 2-3 seconds. You'll get
a display like these telling you the
speaker impedance setting.
(This display indicates a 6
Ω-
less than 8
Ω impedance
setting.)
(This display indicates an
8
Ω-16Ω impedance setting.)
LOUDNESS MIDNIGHT TONE DNR ATT STEREO
TUNED
RDS
Hi-BIT/
MULTI-ROOM
SAMPLING
EON
RF ATT
MONO Neo :6
DIGITAL
DTS ES EX
MPEG AAC
STEREO
PRO LOGIC
DSP
L C R LFE
AUTO
SB CH ON MOVIE
MUSIC OFF
L S S R S
AUTO
RF
DIGITAL
dB SIGNAL
SP A B
ANALOG
LOUDNESS MIDNIGHT TONE DNR ATT STEREO TUNED
RDS
Hi-BIT/
MULTI-ROOM
SAMPLING
EON
RF ATT MONO Neo :6
DIGITAL
DTS ES EX
MPEG AAC
STEREO
PRO LOGIC
DSP
L C R LFE
AUTO
SB CH ON MOVIE
MUSIC
OFF
L S S R S
AUTO
RF
DIGITAL
dB SIGNAL
SP A B
ANALOG
STANDBY/ON
MOVIE MUSIC
MULTI JOG
ENTER
STANDBY MULTI CHANNNEL ACOUSTIC CALIBRATION
AUDIO/VID
PHONES SPEAKERS
SIGNAL
SELECT SB CH
MODE EON MODE CHARACTER/ SEARCH HI-BIT HI-SAMPLING
SETUP MIC
DIGITAL IN S-VIDEO VIDEO VIDEO INPUT AUDIO L R
SET UP RETURN
TONE TONE CONTROL BASS/TREBLE
CLASS BAND STATION TUNING
MULTI JOG/ENTER
MULTI JOG CONTROL SELECT TUNER EDIT
SPEAKERS
STANDBY/ON