Paxar 9430R - Manual (Page 35)

Modifying Resident Fonts 4-3
S e l e c t i n g C h a r a c t e r S e t s
Before selecting a character set, remove the printer’s battery and wait
several seconds. Then, replace the battery and immediately use one of
these commands to select the character set to modify.
When it receives either of these commands, the printer copies the character
set to memory, then sends a ‘?’ character to the host.
The printer returns any characters not accepted as part of this command.
NOTE: Do Not send any commands to the printer between turning it on
and selecting the character set.
Command Summary
Command Description
ESC-'DA0'
Selects characters from the ASCII character
set (33-127).
ESC-'DX'-<charfont> Selects characters and fonts from the
Extended PC Line-Draw or International
character set (128-255).
<charfont> 0
Extended PC Line-Draw characters –
Large Rotated, Large Normal, and
Standard Bold fonts.
1 Extended PC Line-Draw characters –
Standard Normal, Reduced Bold, and
Reduced Normal fonts.
2 International characters –Large Rotated,
Large Normal, and Standard Bold fonts.
3 International characters –Standard
Normal, Reduced Bold, and Reduced
Normal fonts.