Paxar 9430R - Manual (Page 36)

4-4 Modifying Resident Fonts
L o a d i n g N e w C h a r a c t e r s
This step allows you to load the new characters at a particular position in
the set.
Command Summary
Command Description
<ESC>-'D'-<font>-
<code>-<matrix>
Loads a character at a particular position.
<font> The font to save the character in.
Value PC Line-Draw
Fonts
Extended PC
Line-Draw and
International
Fonts
0 Large Normal
Standard Bold Large Normal
Standard Bold
Standard Normal
1 Standard Normal Large Rotated
Reduced Bold
Reduced Normal
2 Reduced Bold
Reduced Normal
<code> The hex character code for the new character:
21 hex – 7F hex (PC Line-Draw) or 80 hex –
FF hex (Extended PC Line-Draw and
International).
#matrix# The hex data from the matrix describing the
new character (see “Defining New
Characters”).
S a v i n g M o d i f i e d F o n t s
To save the modified font into flash memory, use ESC-'D'-FF hex. The
printer sends a ‘D’ character and then performs the save. When the fonts
have been saved, the printer sends a ‘!’ character to the host. Then, it
sends an ‘X’ character every 500 milliseconds.
Next, remove the battery and wait several seconds before replacing it.