Philips HTS3377W/12 - Manual (Page 17)

17
Navigate through the menu
1
Point the remote control directly at the
remote sensor on the Home Theatre
System and select the desired function.
2
Press the following buttons on the
remote control to navigate through the
on-screen menus.
Button Action
Move up or down
Move left or right
OK Confi rm a selection
Enter numbers
Find the correct viewing
channel
1
Press to turn on this product.
2
Press DISC to switch to disc mode.
3
Turn on the TV and switch to the correct
video-in channel in one of the following
ways:
Go to the lowest channel on your •
TV, then press the Channel Down
button until you see the Philips
screen.
Press the
• SOURCE button
repeatedly on the remote control of
your TV.
4 Get started
Insert the remote control
batteries
1
On the back of the remote control, slide
the battery cover to remove it.
2
Insert the 2 supplied batteries (AAA). Be
sure the + and - ends of the batteries line
up with the markings inside the case.
3
Slide the cover back into position.
Note
Do not mix batteries (old and new or carbon •
and alkaline, etc.).
Remove batteries if they are exhausted or if •
the remote control is not to be used for a long
time.
Batteries contain chemical substances, they •
should be disposed of properly.
Control a play source
1
Press RADIO , USB or DISC button to
select the source you wish to control.
2
Select the desired function (for example
, ).
English
EN