Philips HTS5700R - Manual (Page 18)

English
18
8239 300 38591
Tuning to radio stations
1
Press TUNER on the remote (or press
SOURCE control on front panel) to
select “
FM” or “MW”.
2
Press and hold
S / T on the
remote until the frequency indication
starts to change, then release.
➜ "
FM SEARCH" appears.
➜ The next radio station will be tuned
automatically.
➜ lights up for FM stereo reception.
3
To tune a weak station, press
S / T
briefly and repeatedly until an optimal
reception is found.
RDS Function
RDS (Radio Data System) is a
broadcasting service that allows FM radio
stations to send additional information
along with the FM radio. This additional
information includes:
● Frequency
● Station Name
1
In FM mode, if the tuned radio station is
transmitting RDS data, the RDS station
name will be shown on the display panel.
2
Press
S / T button to change the
station frequency to get the new RDS
station.
3
If the tuned station is not transmitting an
RDS signal or is not a RDS station, the
display panel will only show the station
frequency.
Helpful Hint:
- RDS function is only available in areas
that support RDS system.
Presetting radio stations
You can store up to 40 preset radio
stations in the memory.
Automatic presetting
You can store all available radio stations
automatically.
1
In tuner mode, press and hold PROG for
five seconds to enter system setup.
2
Press
S / T to select “AUTO
PROG”.
AUTO PROG
3
Press PROG to confirm.
➜ “
CONFIRM” appears.
4
Press PROG again to start automatic
presetting.
➜ “
SEARCH” appears.
➜ All the available radio stations with
strong transmission signal will be stored.
➜ Automatic preset will begin from
preset (1) and all your former presets will
be overridden.
Manual presetting
You can choose to store only your
favourite radio stations.
1
Tune to your desired radio station (see
“Tuning to radio stations”).
2
Press PROG .
➜ “
PROGRAM
” and “
PRESET
” icons appear.
NIGHT
SLEEP
MUTE
PRESET
PROGRAM
TUNER
3
Use the numeric keypad (0-9) to
select a desired preset number.
➜ If “
PROGRAM
” icon goes off before you
select the desired preset number, press
PROG button again.
Tuner Operations
IMPORTANT!
Make sure the FM and MW
antennas are connected.