Panasonic BT-LH80WP - Manual (Page 19)

19
VIDEO CONFIG
The underlined values are factory preset setting values.
Sub menu Settings Explanation
COLOR TEMP. USER 63∗ 1
D93
D65
D56
VAR1
VAR2
VAR3
Used to select the color temperature.
<USER 0 - 63> Adjustable settings 0 - 63
(color temperature around 3000K - 9300K)
<D93> Color temperature around 9300K
<D65> Color temperature around 6500K
<D56> Color temperature around 5600K
<VAR1> WB adjustment mode∗
2
<VAR2> WB adjustment mode∗ 2
<VAR3> WB adjustment mode∗ 2
SHARPNESS
MODE HIGH∗ 3
LOW
Used to select the width of the sharpness edge.
<HIGH> Thin edge <LOW> Thick edge
SHARPNESS H 0 - 30∗ 3 Used to set the sharpness in the horizontal direction.
When adjusting, the item display moves to the lower part of the
screen.
SHARPNESS V 0 - 30∗ 3 Used to set the sharpness in the vertical direction.
When adjusting, the item display moves to the lower part of the
screen.
I-P MODE MODE2
MODE1 Used to select IP conversion mode. (→ page 20 “About IP Mode”)
<MODE2> Field Interpolation <MODE1> Frame Interpolation
MONO∗ 4 OFF
ON Used to switch between color and monochrome (MONO).
<OFF> Color <ON> Monochrome
∗ When this is ON, the picture adjusting knob [CHROMA] setting is
fixed at 0.
SD ASPECT∗ 4 4:3
16:9 Used for setting the aspect ratio settings when using SD signal
input.
<4:3> 4:3 display <16:9> 16:9 display
∗1 When selecting USER 0 - 63
1) Push [ENTER] (USER changes to blue). 2) Select 0 - 63 with [
, ], and push [ENTER].
∗2 When “VAR1”, “VAR2” or “VAR3” is selected, the monitor switches to WB adjustment mode (→ page 20).
∗3 The following sharpness values can each be set,
1) VIDEO system input line (VIDEO)(Factory settings are SHARPNESS MODE: LOW, SHARPNESS H/V: 0)
2) any other input line’s HD (Factory settings are SHARPNESS MODE: HIGH, SHARPNESS H/V: 0)
3) any other input line’s SD (Factory settings are SHARPNESS MODE: LOW, SHARPNESS H/V: 0)
and the setting values for the selected input signal from within this group is displayed. The adjustment status is
displayed in the bottom right when selected.
∗4 During GPI control, the setting items are displayed in gray and the display changes in accordance with the GPI
control.
Main Menu
(continued)