Panasonic BT-LH80WP - Manual (Page 29)

29
INPUT SELECT
The underlined values are factory preset setting values.
Sub menu Settings Explanation
YP
B
P
R
ON
OFF Used to set the YP
B
P
R
line to the INPUT SELECT button.∗ 1
COMPONENT
LEVEL SMPTE
B75
B00 Used to select the input level for the YP
B
P
R
(component) signal.
<SMPTE> When the signal level specified in SMPTE is Chroma 100
IRE, P
B
, P
R
=0.7Vp-p
<B75> Select this when connecting a betacam or similar devices
with a 7.5 IRE setup level.
<B00> Select this when connecting a betacam or similar devices
with a 0 IRE setup level.
VF ON
OFF Used to set the VF line to the INPUT SELECT button.∗ 1
VIDEO/YP
B
P
R
VIDEO
YP
B
P
R
Used to select the VF input mode.
<VIDEO> Selects the VIDEO signal.
<YP
B
P
R
> Selects the YP
B
P
R
(component) signal.
SIGNAL TYPE HD
SD Used to select the signal output from the camera.
<HD> Selects the HD signal.
<SD> Selects the SD signal.
VIDEO ON
OFF Used to set the VIDEO line to the INPUT SELECT button.∗ 1
FORMAT AUTO
NTSC
PAL Used to select the format for VIDEO input.∗ 2
<AUTO> NTSC or PAL is selected automatically.
<NTSC> NTSC
<PAL> PAL
NTSC SETUP 00
75 Used to set the setup level for NTSC.
<75> Select this when the signal is at a 7.5 IRE setup level.
<00> Select this when the signal is at a 0 IRE setup level.
SDI ON
OFF Used to set the SDI line to the INPUT SELECT button.∗ 1
∗
3
∗1 When an SDI input unit (option) is installed, it is not possible to switch OFF all the 4 input lines. An OFF setting
cannot be made for the 4th input line.
When there is no SDI input unit (option), it is not possible to switch OFF all the following 3 input lines: YP
B
P
R
,
VIDEO or VF. An OFF setting cannot be made for the 3rd input line.
∗2 Although the factory preset setting is AUTO, we recommend specifying a format because there is a risk of the
input signal being affected by external noise.
∗3 When there is no SDI input unit (option), the SDI item is displayed in gray and cannot be set.
Main Menu
(continued)