Panasonic BT-LH80WP - Manual (Page 36)

36
Error/Warning Displays
If for any reason an error occurs in the unit, the user is alerted of error or warning with the following displays.
Error/Warning Display Solution
Inverter error All the lamps on the side of
picture adjusting knobs flash at
1-second intervals. Switch the power supply OFF once, then switch it
back ON again. If an error is still displayed, contact
the vendor where you purchased the unit.
Warning of improper
operation status for the
camera settings
is displayed.
Check the setting values of the camera.
Battery level warning The voltage display flashes. Replace with a fully charged battery.
Battery level error “END BATTERY” is displayed for
approximately 3 seconds before
the power supply switches OFF. Replace with a fully charged battery.
Maintenance
• To clean the cabinet or surface of the liquid crystal protection panel, gently wipe with a soft, dry cloth.
If the surfaces are extremely dirty, use a soft cloth dipped in a weak detergent solution and then wrung-out to clean
the surfaces, then use a dry cloth to finish. Water or similar substances getting inside the monitor can cause a
malfunction.
• Never use thinner or benzene to clean this unit.
Doing so would cause the surface of the monitor to become discolored, and cause paint to peel.
• Do not spray cleansers directly onto the monitor.
Water or similar substances getting inside the monitor can cause a malfunction.
Specifications
GENERAL
Power supply: DC 12 V (11.0 V to 17.0 V)
Input current: 1.5 A
indicates safety information.
Dimensions (W × H × D): 218 mm × 166 mm × 64.7 mm
(8-9/16 inches × 6-9/16 inches × 2-9/16 inches)
Weight: 1.5 kg (3.3 lb)
Operating temperature: 0 °C to 40 °C (32 °F to 104 °F)
Operating humidity: 10 % to 85 % (no condensation)
Storage temperature: –20 °C to +60 °C (–4 °F to +140 °F)
Panel
Size: 7.9-inch V (Effective display area)
Aspect ratio: Panel: 16:9 (Effective display area)
Number of pixels: Panel: 800 × 450 (Effective display area)
Display colors: Approx. 16.77 million colors
Angle of view: Top-bottom direction: 110 ° Left-right direction: 120 °
Input connectors
VIDEO: 1 line, BNC × 1 (Shared with the analog component Y input terminal)
Analog component (YP
B
P
R
): 1 line, BNC × 3
(Of these, the Y input terminal is shared with the VIDEO input terminal)
SDI: 1 line, BNC × 1 (Optional)
VF: D-sub, 15 pins × 1
GPI: D-sub, 9 pins × 1
RS-232C: D-sub, 9 pins Ч 1