Panasonic AJ-SD930BE - Manual (Page 32)

32 (E)
CONTENTS
Setup menus
1
Press the MENU button.
2
Press the REW button or FF button while holding
down the DIAG button to select the USER1 file.
4
Turn the search dial while holding down the search
button to select the user file in which the contents
of USER1 are to be saved.Those user files which
have been set to the lock mode do not appear on
the display. If all the user files have been set to the
lock mode, the “LOCKED” display appears, and
the contents of USER1 cannot be saved into any of
the user files.
3
Turn the search dial to move the cursor (2) on the
menu screen to No. A01 (SAVE).
Saving user files
Automatically recalling a user file
when turning on the power
If the user file to be loaded is selected in advance
using setup menu No. A02 (P.ON LOAD), the file will
be automatically loaded into USER1 when the power
is turned on.
SETUP-MENU MENU
<USER1> NO.A00-0000
804 BLANK LINE BLANK
A00 LOAD USER2
2 A01 SAVE USER2
A02 P.ON LOAD OFF
END
5
Press the SET button.
The following message appears on the menu
screen and counter display.
SETUP-MENU SAVE
USER1 n USER2 OK?
YES<PLAY>/NO<STOP>
Menu screen
Counter display
The number of the user file selected in step
4
is
displayed at .
6
Press the PLAY button.
The settings of USER1 are saved in the user file
selected in step
4
and stored in the memory. If the
STOP button is pressed instead, the settings are
not changed, and the USER1 menu display
appears.
7
Turn the search dial to move the cursor (2) on the
menu screen to a number other than No. A00
(LOAD) or No. A01 (SAVE).
8
Press the SET button. The USER1 settings are
stored in the memory.
If the USER1 settings are not to be stored in the
memory, do not press the SET button but press the
MENU button instead.