Manual tune, Helpful hint, Tuning channels – Panasonic TC-43P250H User Manual
Page 27
27
The best tuning position is automatically
memorized.
Manual Tune
(Channel Select and Regional System must already be set; Refer to pages 21)
MANUAL TUNE
Press to select the MANUAL TUNE.
Press to access to the MANUAL TUNE.
Search Start.
1
CH 12
29
MANUAL TUNE
PROGRAMME - /+
SEARCH - /+
RETURN
TV / AV - EXIT
‘STR’ BUTTON-STORE
Press to select the desired Programme
Number.
Press to select the higher or lower channel.
SOUND SYS
Press to confirm the sound condition of each
Programme Number.
Press to improve the Sound quality, if the Sound
is not clear or no sound is produced on a
programme Number Position.
4.5MHz
6.5MHz
5.5MHz
6.0MHz
SYS SELECT
CH SELECT
AUTO TUNE
MANUAL TUNE
FINE TUNE
SKIP
SOUND SYS
6. 0MHz
COLOUR SYS
AUTO
OFF
JAPAN
POSITION
TUNING MENU
Note:
When sound volume is too small to confirm, tune it up by using the sound volume button on the remote control.
2
1
2
3
Helpful Hint
(1) If a clear picture with correct colours cannot be obtained when a Broadcast or AV signal is received, refer to the
“Colour System Selection” operation on page 23.
(2)
(3) When using a VCR without video and audio input/output terminals, it is convenient to connect the aerial cable as
indicated in the instruction manual of VCR and to set the designated channel to programme No. “0”. In that case,
perform manual tune after setting the colour system and sound system in advance. Further, in multi-system VCR,
it is more convenient to set the designated channel to several programme Numbers.
After the Manual tune is finished, press this button to confirm the tuning condition for each
Programme Number. If some Programme Numbers are unused (no TV stations), it is possible to
skip such Programme Numbers. Please refer to the Programme Number Skip operation on page
29.
SYS SELECT
CH SELECT
AUTO TUNE
MANUAL TUNE
FINE TUNE
SKIP
SOUND SYS
6. 0MHz
COLOUR SYS
AUTO
OFF
ACCESS
JAPAN
POSITION
TUNING MENU
Tuning Channels
TV/AV
Press to exit from the Tuning Menu.
This returns the set to the normal viewing condition.
When found a station.