Panasonic TC-43P250H - Manual (Page 31)

31
Picture Adjustment
Set the overall colour tone of the picture. C. TEMP
(Colour Temperature)
P-NR
(Picture Noise
Reduction)
AI
SCAN MODE
Press to switch between modes
STANDARD
MENU
CONTRAST
BRIGHTNESS
COLOUR
SHARPNESS
C. TEMP
STANDARD
PICTURE
NTSC-TINT
COOL WARM STANDARD
Automatically reduces undesired picture noise.
TC-43P250H, TC-51P250H: Switching is also
possible using
D.PNR
on the remote control.
Automatically analyses the incoming picture
and processes it to give improved contrast and
optimum depth of field.
Choose the screen refresh method:
Press to switch between modes
WEAK
STRONG OFF
AUTO
AI
SCAN MODE
AUTO
ON
PICTURE
P-NR AUTO
AI
SCAN MODE AUTO
ON
PICTURE
P-NR AUTO
TC-43P250H, TC-51P250H: Switching is also
possible using
P. AI
on the remote control.
Press to switch between modes
PROGRESSIVE 100 Hz MODE AUTO
AI
SCAN MODE AUTO
ON
PICTURE
P-NR AUTO
MODE Function
AUTO
100 Hz MODE
PROGRESSIVE
The TV software will select the best mode for the signal being viewed.
100Hz will give a steady picture for most signal transmission.
Recommended when receiving NTSC signals.
Note:
We recommend that you set Scan mode to Progressive when viewing a PAL 60 or
NTSC transmission. When viewing a PAL transmission (other than PAL 60) with Scan
mode set to Progressive, the screen will flicker, this is not a fault.
By pressing the Normal “N” Button on the Remote Control while the Picture menu is displayed, the selected menu will
be changed to the Normal Mode.
Normalization will not occur if the menu is not displayed when the “N” Button is pressed.
The Normal mode is the factory preset condition. Returning to this original condition is called “Normalization”.
Switching is also possible using
100Hz/
PROGRE on the remote control.
Helpful Hint (
N
Normalization)