Philips MX5500D/21 - Manual (Page 18)

18
English
Step 1: Inserting batteries into
the remote control
1
3
2
1
Open the battery compartment.
2
Insert two batteries type R06 or AA, following
the indications (+-) inside the compartment.
3
Close the cover.
Using the remote control to operate
the system
1
Aim the remote control directly
at the remote sensor (iR) on the
front panel.
2
Select the source you wish to
control by pressing one of the
source select buttons on the
remote control (for example
TV/AV, TUNER).
3
Then select the desired function
(for example ÉÅ,
S,
T).
CAUTION!
– Remove batteries if they are
exhausted or if the remote is not to be
used for a long time.
– Do not use old and new or different
types of batteries in combination.
– Batteries contain chemical substances,
so they should be disposed of properly.
Step 2: Setting the clock
The clock can be set in either 12-hour or
24-hour mode ("12:00 AM" or "00:00" for
example).
CLOCK•TIMER
CLOCK•TIMER
SEARCH
PROG
CLOCK•TIMER
2
3
5
4
6
SELECT CLOCK OR TIMER
CLOCK
01:38 PM
13:38
13:38
1
Press STANDBY ON to switch on the DVD
system.
2
Press and hold CLOCK•TIMER until
"SELECT CLOCK OR TIMER" appears.
3
Press T (if necessary) to change the display
to "CLOCK", then press
CLOCK•TIMER again
to confirm.
4
Press S / T to set the minutes and hours.
To increase the speed, hold down
S or T.
➜ The changes in minutes will roll over to the
hours.
5
Press PROG to change between 12-hour and
24-hour clock mode.
6
Press CLOCK•TIMER again to store the
setting.
➜ The clock will start working.
To view the clock time in any active
mode
● Press CLOCK•TIMER.
➜ The clock will display for a few seconds.
Notes:
– If the DVD system is disconnected from the
power supply, it will erase the clock setting.
– If you do not press any buttons within 90
seconds, the system will exit clock setting mode.
STANDBY- ON iR SENSOR
DISC 1
DISC 2
DISC 3
DISC 4
DISC 5
DISC 1 DISC 2 DISC 3
OPEN•CLOSE
1 2 3
4 5 6
7 8 9
0
REPEAT REPEAT DISC SKIP
DISC MENU
PROGRAM
SYSTEM MENU
SEATING ZOOM
PREV NEXT
SURR. SOUND
VOL
OK
TV/AV
DISC/
MEDIA TUNER AUX/DI
STOP PLAY/PAUSE
buttons on
front panel DVD system’s
display panel
Getting Started