Philips MX5500D/21 - Manual (Page 36)

36
English IMPORTANT!
– Make sure the FM and MW antennas
are connected.
– The TUNING button on the front
panel is used to toggle between
frequency tuning and preset tuning.
When in preset tuning mode, pressing
S / T buttons on the front panel
will change the preset number.
Otherwise, pressing
S / T will
change the radio frequency.
Tuning to radio stations
1
Press TUNER on the remote (or adjust
SOURCE control on front panel) to select
“FM TUNER” or “MW TUNER”.
2
Press and hold
S / T on the remote until
the frequency indication starts to change, then
release.
➜ The next radio station will tune automatically.
➜ lights up for FM stereo reception.
3
To tune a weak station, press
S / T briefly
and repeatedly until an optimal reception is
found.
● If you use
S / T on the front panel for
frequency tuning, make sure the system is in
frequency tuning mode. If not, press
TUNING.
➜ "FREQ MODE" appears.
Presetting radio stations
You can store up to 40 preset radio stations in
the memory, starting from FM and followed by
MW bands.
Notes:
– The system will exit presetting mode if no
button is pressed within 20 seconds.
– If no stereo frequency is detected during Plug
and Play, "CHECK ANTENNA" appears.
Using the Plug and Play
Plug and Play allows you to store all available
radio stations automatically.
DVD VIDEO DIGITAL SURROUND SYSTEM
STOP PLAY• PAUSE SEATING
TREBLE
BASS
SOURCE VOLUME
PROG TUNING CLOCK•TIMER
SURROUND SEARCH
SC CHANGER
EJECT MEDIA SLOT
DVD DISC
SU R- R
RIG H T
CENTRE
LE FT
SUB
SU R-L
MIC LEVEL MIC
PLAY• PAUSE
AUTO INSTALL - PRESS PLAY
1
Connect the system to the power supply,
"AUTO INSTALL - PRESS PLAY" appears.
OR
In Eco Power standby/standby mode,
press and hold ÉÅ
on the front panel until
"AUTO INSTALL - PRESS PLAY" appears.
2
Press ÉÅ on the front panel to start
installation.
➜ "INSTALL TUNER" appears.
➜ All previously stored radio stations will be
replaced.
➜ Once completed, the last tuned radio station
will play.
Tuner Operations