Philips MX5500D/21 - Manual (Page 21)

English
21
Getting Started
Setting the speakers’ channels
You can adjust the delay times (centre and
surround only) and volume level for individual
speakers. These adjustments let you optimise
the sound according to your surroundings and
setup. Speaker settings are only active on Multi-
channel audio outputs.
1
Press SURR. (or SURROUND on the front
panel) repeatedly to select ‘Multi-channel’.
2
In disc mode, press SYSTEM MENU.
3
Select icon and press 4.
4
Use the joystick (1 2 3 4) on the remote to
navigate in the menu.
Move to and press 2.
Move to ‘Speakers’ and press 2.
5
Press 3 4 to select (Front L&R, Center,
Surr L&R, Sub Woofer), then press 2 to enter
the speaker setting menu.
➜ The test tone will be automatically generated.
6
Use 3 4 to adjust the settings for each
speaker to suit your surround sound needs. This
adjustments may include :
A
Turning on or off the sound output.
B Delay time settings - use the longer delay
settings when the surround speakers are
closer to the listener than the front speakers.
C Adjusting the volume levels for one or both
speakers until the sound evens.
7
Press OK to confirm.
To remove the menu
Press SYSTEM MENU.
Step 5: Setting language
preference
You can select your preferred language settings
so that this DVD system will automatically
switch to the language for you whenever you
load a disc. If the language selected is not
available on the disc, the disc’s default setting
language will be used instead. Except the DVD
system’s menu language, it will remain once
selected.
1
In disc mode, stop playback and press SYSTEM
MENU.
2
Select icon and press 4.
3
Use the joystick (1 2 3 4) on the remote to
navigate in the menu.
Move to and press 2.
Move to ‘Menu Language’ and press 2.
4
Select a language and press OK.
5
Use the joystick (1 2 3 4) on the remote to
navigate in the menu.
Move to and press 2.
Move to one of the following and press 2.
– ‘Audio Language’ (disc’s soundtrack)
– ‘Subtitle’ (disc’s subtitles)
– ‘Disc Menu’ (disc’s menu)
6
Select a language and press OK.
7
Repeat steps
5
~
6
for other settings.
To remove the menu
Press SYSTEM MENU.
SETUP MENU ➠
Personal setting ...
Set Speaker Settings
Digital Output
Analog Output
Night mode
Speaker Layout
Speakers
PCM Output
Front L & R
Center
Surr L & R
Sub Woofer
OK to exit
3 dB 6 dB On 3 ms
A B C
English
Français
Parental Control
Password
Defaults
Menu Language
Audio Language
Subtitle
Disc Menu
English
English
English
Go to language setup page