Philips MIIC-201D/U - Manual (Page 29)

23
4.2 Command Line Arguments
The Message Center can be controlled via command line arguments. This feature
allows the Message Center to be accessed from a batch file or another program.
Message Center
Command Line Arguments
Command Description
iPort, iPort/AI, iPort/AFM, Variable,
iPort/USB, iPortDLL/USB Specify I 2 C adapter type.*
COM1...COM20 Specify RS-232 communication port.
BAUD19200, BAUD57600, BAUD115200 Set RS-232 Baud Rate.*
CLOCK12.5K, CLOCK23K, CLOCK86K,
CLOCK100K, CLOCK400K, VCLOCK Set I 2 C Bus Clock Rate.*
Monitor/INT Enable /INT Signal Monitor.*
StopOnBusy Stop sending on I 2 C adapter busy.
StopOnArbLoss Stop sending on I 2 C Bus Arbitration Loss.
StopOnNak Stop on Slave Negative Acknowledgment.
BeepOnBusy Beep on I 2 C adapter busy.
BeepOnArbLoss Beep on I 2 C Bus arbitration loss.
BeepOnNak Beep on Slave Negative Acknowledgment.
BeepOn/INT Beep on /INT signal assert (low).*
AutoLoad Load I 2 C message list file.
AutoSave Save I 2 C message list file.
AutoOpen Open link to I 2 C adapter.
AutoSend Send I 2 C message list.
AutoExit Exit after sending message list.
* Adapter specific commands. See command details below.
Command Line Syntax: imsgctr.exe AdapterType argument-list
Example: imsgctr.exe iPort/AFM adctest01.iml AutoOpen AutoSend AutoExit