ParaBody 883 - Manual (Page 28)

28
STEP 19:
FIGURE 19
• Route the new PRESS STACK CABLE (7) thru the REAR UPRIGHT as shown. (NOTE: Remove pulleys for ease of installa-
tion.) Slide GUIDE RODS up just enough to get the cable end thru. Push GUIDE RODS down when finished.
STEP 20:
FIGURE 20
• Screw the threaded end of the PRESS STACK
CABLE (7) into the end of the HEAD
PLATE. See FIGURE 20.
• Route the new PRESS STACK CABLE (7)
around the pulleys in the BOOM BRACKET
using the existing bolts as shown in
FIGURE 20. (NOTE: Make sure the cable
runs in the grooves of the pulleys.)
7
BOOM
BRACKET
HEAD
PLATE
7