Panasonic KX-HGW200 - Manual (Page 14)

14
Preparation
Before starting to install the KX-HGW200, make sure that you have
everything below and all the devices are turned off.
≥ A Windows or Macintosh computer with web browser software*, a network
card (Ethernet, HomePNA or wireless card) and TCP/IP installed.
≥ A cable/xDSL modem with a cable
≥ An Internet access account and information provided by the ISP
*See “System Requirements” on p. 8 for recommended browsers.
Connecting the KX-HGW200 to a Cable/xDSL Modem
1 Make sure the cable/xDSL modem is turned off.
2 Connect the category 5 straight cable (with 8-pin RJ-45 connector) to
the RJ-45 jack of the cable/xDSL modem.
3 Connect the other end of the category 5 straight cable to the
TO MODEM port of the KX-HGW200.
TO MODEM port
To RJ-45 jack
on the Cable/xDSL
modem
Category 5
straight cable
“ Setup
PQQX12817ZA \1-P29 01.3.8 3:17 PM y [ W 14