Panasonic KX-HGW200 - Manual (Page 16)

16
“ Setup
3 Connect the computer to the wall mounted single-line telephone jack.
For more detailed information, refer to the HomePNA card manual.
4 If you are thinking of attaching a telephone to the KX-HGW200, follow
the steps below (a, b and c). If not, skip these steps.
a: Connect the end of the telephone line cord to the PHONE jack on
the KX-HGW200.
b: Connect the other end of the telephone line cord to the single-line
telephone jack of the telephone.
c: Make sure a dial tone is heard from the handset of the telephone.
To connect computers using optional wireless cards:
An optional Panasonic wireless card, model KX-HGC200, is required for the
KX-HGW200 and for each computer in the network.
≥ Before you insert the wireless card into the KX-HGW200, turn off the
KX-HGW200 by removing the AC adaptor.
≥ Install a Panasonic wireless card in the wireless card slot of the
KX-HGW200 and in the appropriate PCMCIA slot of the computer(s). The
driver software that comes with the optional wireless card must be
installed in the computer.
≥ To install the optional Panasonic wireless card KX-HGC200 and the driver
software in either the KX-HGW200 or a computer, refer to the operating
instructions that come with the wireless card.
The KX-HGW200 is compatible with the optional Panasonic wireless card
KX-HGC200 only. Do not insert any other PCMCIA card into the
KX-HGW200.
Telephone
PHONE jack
Telephone line
cord
PHONE
PQQX12817ZA \1-P29 01.3.8 3:17 PM y [ W 16